NHTSA Service Bulletin 10187553: 2018-2021 Honda Gl1800
Official manufacturer communication context for 2018-2021 Honda Gl1800, with affected products, buyer checks and links into Carchieve recall, problem and VIN research.
Reviewed June 2026 from NHTSA manufacturer communication and service bulletin records. Carchieve is independent and not affiliated with any vehicle manufacturer or government agency.
The Wrench - When performing the Service Bulletin GL1800 #1- Loose Handlebar Repair on 2018 GL 1800, or removing the Steering Bridge to adjust the upper steering stem nut on any 2018 and newer GL1800, the left rear tie rod bolt needs to be held by a 14 mm open wrench to prevent the bolt from turning when loosening the 17 mm upper nut. If the bolt is not supported, the rubber bushing will be damaged, which will then need to be replaced. Bushing damage will not be covered by warranty.
What this bulletin may mean before buying
Treat this as service research, not a verdict on one car. Before you buy, compare this communication with official recall campaigns, model-level owner complaint patterns, and the exact vehicle’s VIN-decoded specifications. A bulletin can help you ask a seller or dealer sharper questions about software updates, known repairs, warranty extensions and service history.
Affected products listed in this communication
Buyer checklist
- Run the 17-character VIN and confirm the year, make, model, engine and equipment match the listing.
- Check recall campaign pages for safety actions that may require dealer repair.
- Compare this bulletin with common problem pages for the same model and component area.
- Ask the seller or dealer whether the bulletin procedure, update or inspection has already been completed.
- Use the used-car buying checklist and get an independent inspection.
Frequently asked questions
What is NHTSA service bulletin 10187553?
The Wrench - When performing the Service Bulletin GL1800 #1- Loose Handlebar Repair on 2018 GL 1800, or removing the Steering Bridge to adjust the upper steering stem nut on any 2018 and newer GL1800, the left rear tie rod bolt needs to be held by a 14 mm open wrench to prevent the bolt from turning when loosening the 17 mm upper nut. If the bolt is not supported, the rubber bushing will be damaged, which will then.
Is a service bulletin the same as a recall?
No. A recall is a safety campaign with a required remedy for affected VINs. A service bulletin or manufacturer communication usually describes diagnostic, repair, software, warranty or service information.
How should a used-car buyer use this bulletin?
Use it as a research signal. Compare it with recalls, owner complaints, service records, a VIN report and an independent inspection before buying.
Check the exact VIN before you buy
Model-level pages show public safety patterns. A full VIN report helps confirm the exact vehicle, decoded specs, recall applicability and buyer checks.
Get Full Report