NHTSA Service Bulletin 10191599: 2005-2020 Altec Digger Derrick
Official manufacturer communication context for 2005-2020 Altec Digger Derrick, with affected products, buyer checks and links into Carchieve recall, problem and VIN research.
Reviewed June 2026 from NHTSA manufacturer communication and service bulletin records. Carchieve is independent and not affiliated with any vehicle manufacturer or government agency.
Some customers have reported cracks occurring in the stationary frame tubes above the chassis frame rails of some HD35A pressure diggers built from 2005 through 2020. Investigation has shown this to be caused by improper orientation of the spacer blocks welded to the bottom of the stationary frame tubes. Altec requires the stationary frame on each unit to be inspected no later than the next preventive maintenance interval. If the inspection shows that the spacer blocks are oriented incorrectly, the unit must be repaired no later than 30 days after the inspection using the Repair Procedure provided in the notification.
What this bulletin may mean before buying
Treat this as service research, not a verdict on one car. Before you buy, compare this communication with official recall campaigns, model-level owner complaint patterns, and the exact vehicle’s VIN-decoded specifications. A bulletin can help you ask a seller or dealer sharper questions about software updates, known repairs, warranty extensions and service history.
Affected products listed in this communication
Buyer checklist
- Run the 17-character VIN and confirm the year, make, model, engine and equipment match the listing.
- Check recall campaign pages for safety actions that may require dealer repair.
- Compare this bulletin with common problem pages for the same model and component area.
- Ask the seller or dealer whether the bulletin procedure, update or inspection has already been completed.
- Use the used-car buying checklist and get an independent inspection.
Frequently asked questions
What is NHTSA service bulletin 10191599?
Some customers have reported cracks occurring in the stationary frame tubes above the chassis frame rails of some HD35A pressure diggers built from 2005 through 2020. Investigation has shown this to be caused by improper orientation of the spacer blocks welded to the bottom of the stationary frame tubes. Altec requires the stationary frame on each unit to be inspected no later than the next preventive maintenance.
Is a service bulletin the same as a recall?
No. A recall is a safety campaign with a required remedy for affected VINs. A service bulletin or manufacturer communication usually describes diagnostic, repair, software, warranty or service information.
How should a used-car buyer use this bulletin?
Use it as a research signal. Compare it with recalls, owner complaints, service records, a VIN report and an independent inspection before buying.
Check the exact VIN before you buy
Model-level pages show public safety patterns. A full VIN report helps confirm the exact vehicle, decoded specs, recall applicability and buyer checks.
Get Full Report